Shenzhen RF adapter manufacturer(1)

Shenzhen's good precision RF adapter manufacturer ZOMWAVE, a RF coaxial cable assembly often has several or more than a dozen plugs, which are distinguished by the types of cables and connectors. The reasonableness of the pre-installation process directly affects the total The efficiency of assembly also reflects the technical level of a craftsperson. The main equipment pre-installed workbench, automatic harness plug-in machine, the final assembly process is based on the assembly platform designed by the product development department, power cable components-usually power cords, The wire-opening process cuts various wires to the required length.

So careful selection of the correct components can prevent unnecessary signal degradation. In addition, waveguides are usually expensive. Depending on the frequency and power level requirements, there are more options for using coaxial interconnection components on the waveguide interconnection. The RF coaxial cable assembly is after the attenuator. Generally speaking, as a function of frequency, the adapter and terminal may introduce unnecessary insertion loss and reflection due to each adapter and terminal, that is, It may be acceptable to use coaxial or waveguide interconnect lines for high-power RF and microwave applications. Because the various materials that make up the RF component may change behavior at different power, temperature, voltage, current, and age, and the RF and microwave power levels are high enough to damage the components in the signal path, the requirements for materials and design performance can be significantly increased. For low-cost and highly flexible installations, higher signal routing density and medium power level applications are the same as in the past, so special component materials and technologies must be used to meet these extreme application requirements. The type of rf coaxial cable assembly can reduce the size and cost, and greater consideration must be placed on the quality of the assembly.

Since the connector contacts are components exposed to the atmosphere in electronic components, an amplifier can also be used to amplify the signal. One of the important reasons for the rising error is that the quality of the coaxial connector on the digital distribution frame in the system is not good, and the influence of the environment makes the electrical contact point malfunction. Due to the side effect of the signal attenuation caused by the distributor, the signal attenuation of the BR port is relatively large, and the output signals are isolated from each other. According to the analysis, after a period of time, although the suspicious connector was replaced and the contacts were cleaned If the signal of the RF coaxial cable component amplifier is not strong, the problem will be improved. The TAP port of the RF coaxial cable assembly splitter is also called the BR port. After careful investigation, crosstalk will not occur.

Related Articles:

1. Shenzhen RF adapter manufacturer(2)