How to phase match long phase stable cbale assembly?

For long phase stable cable assembly (length > 1m), due to the influence of media inhomogeneity, if only the mechanical length of consistency is guaranteed, then after assembly, it will be found that the phase dispersion is very serious, and the reworking workload is very large, sometimes it is not even clear which phase stable cbale assembly should be trimmed, and the scrap volume is also very large. The amount of scrap is also very large. Therefore, in order to reduce the workload of component rework, improve the efficiency of component alignment, and reduce scrap, the length of the assembly is measured by a test instrument as an auxiliary means during the assembly process, and the electrical length is ensured to be consistent after cutting, and then the assembly is carried out.

Cutting this step may seem relatively simple, but also need to pay attention to some details, do not rush to a step in place, a more reasonable approach is to cut in multiple times, gradually in place, so as not to cut too short easy to cause scrap.  As the cutting process is to find the shortest electrical length of that phase stable cable assembly, and then the rest of the phase stable cbale assembly according to this length cut, so the process to phase stable cbale assembly number, and make a good record.  The third step is to install the assembly and trim the phase. Based on the completion of the first two steps, the next step is to install the other end of the connector, and after the installation is completed, the phase of each phase stable cbale assembly is measured and recorded.

ZOMWAVE provied phase stable cable assembly with high performance and low price, click blue words and learn more.